Prg AutoPar User Manual 2.1 Manual do Utilizador

SOFTWARE VERSION 2.1WWW.PRG.COMAUTOPAR® WASH LUMINAIREUSER MANUAL

2 AUTOPAR® WASH LUMINAIRE USER MANUALCustomer ServiceFor technical assistance, contact the PRG International Service Center or contact your nearest PR

1.DESCRIPTIONThis chapter contains descriptions of luminaire features, components, and accessories.+FEATURES+ COMPONENTS

4 AUTOPAR® WASH LUMINAIRE USER MANUALFEATURESOverviewThe AutoPar Wash Luminaire from PRG Lighting is a compact, lightweight fixture which incorporates

AUTOPAR® WASH LUMINAIRE USER MANUAL 5COMPONENTSIncluded ItemsThe following illustration shows all items included with the luminaire:Figure 1-1: AutoP

6 AUTOPAR® WASH LUMINAIRE USER MANUALMajor Components and ControlsThe following illustration shows the external luminaire components and controls.Figu

2.INSTALLATIONThis chapter contains instructions for installing the luminaire. It includes connecting power and data, along with instructions for pow

8 AUTOPAR® WASH LUMINAIRE USER MANUALPOWER AND DATA CABLING REQUIREMENTSPowerThe AutoPar Wash Luminaire requires standard AC power distribution from 1

AUTOPAR® WASH LUMINAIRE USER MANUAL 9The XLR 5-pin connectors should be wired as follows:Note: Refer to the USITT Recommended Practice for DMX512 gui

10 AUTOPAR® WASH LUMINAIRE USER MANUALMale Termination ConnectorA male XLR termination connector is required at the last luminaire (or "far end o

AUTOPAR® WASH LUMINAIRE USER MANUAL 11INSTALLATION PROCEDUREHanging the LuminaireThe AutoPar wash luminaire can be hung horizontally or vertically fro

AutoPar®, Bad Boy®, PRG Series 400®, Mbox Extreme®, V676®, Virtuoso®, Virtuoso® DX, Virtuoso® DX2, and VL6C+™are trademarks of Production Resource Gr

12 AUTOPAR® WASH LUMINAIRE USER MANUALInstalling in Truss:Step 1. Attach hardware and loop safety cable through mounting bracket slot (Figure 2-2).Ste

AUTOPAR® WASH LUMINAIRE USER MANUAL 13Floor Mounting the LuminaireThe luminaire enclosure is sufficient to stabilize the luminaire in a floor installa

14 AUTOPAR® WASH LUMINAIRE USER MANUALPOWER UP PROCEDUREPowering Up the LuminaireWhen AC power is applied, the luminaire will begin a calibration sequ

AUTOPAR® WASH LUMINAIRE USER MANUAL 15Programming a Starting AddressThe address setting for DMX512 systems is programmed at the Menu Display (refer to

16 AUTOPAR® WASH LUMINAIRE USER MANUALNotes

3.OPERATIONThis chapter contains instructions for using the Menu Display system and controlling the luminaire by DMX512.+MENU SYSTEM+ DMX512 OPERATION

18 AUTOPAR® WASH LUMINAIRE USER MANUALMENU SYSTEMOverviewThe menu system is a programmable set of commands used to configure, address, and report stat

AUTOPAR® WASH LUMINAIRE USER MANUAL 19Menu FunctionsThe following is a graphic representation of the menu system. Fixture, Dmx, Lamp and Test are top

20 AUTOPAR® WASH LUMINAIRE USER MANUALDMX512 OPERATIONChannel MappingThese tables assume a DMX512 start address of 1. When a different starting addres

AUTOPAR® WASH LUMINAIRE USER MANUAL 21Control Channel FunctionsControl channel functions allow special actions such as reset, douse and start. These m

AUTOPAR® WASH LUMINAIRE USER MANUAL IFOREWORDCompliance NoticeThis device complies with Part 15 of the FCC rules. Operation is subject to the followin

22 AUTOPAR® WASH LUMINAIRE USER MANUALLUMINAIRE TIMINGTiming Channel InformationTiming channel control allows for smoother transition and movement of

AUTOPAR® WASH LUMINAIRE USER MANUAL 23Timing channels can be set in either % or 0-255 (DMX) modes, with the following values assigned:Table 3-1: DMX M

24 AUTOPAR® WASH LUMINAIRE USER MANUAL81 2232 82 2283 2333 84 2385 2386 2434 87 2488 2535 89 2590 2591 2636 92 2693 2737 94 2795 2796 2838 97 2898 293

AUTOPAR® WASH LUMINAIRE USER MANUAL 25165 5565 166 55167 5666 168 56169 56170 5767 171 57172 5868 173 58174 58175 5969 176 59177 59178 6070 179 60180

26 AUTOPAR® WASH LUMINAIRE USER MANUAL249 30098 250 300251 31099 252 310253 310254 310100 255 Follows Cue DataTable 3-1: DMX Mapping (Continued)% Val

4.TROUBLESHOOTING AND MAINTENANCEThis chapter provides a basic troubleshooting guide, along with procedures for extended care of the luminaire.+TROUBL

28 AUTOPAR® WASH LUMINAIRE USER MANUALTROUBLESHOOTINGError MessagesAfter calibration, the Menu Display will cycle through any applicable error message

AUTOPAR® WASH LUMINAIRE USER MANUAL 29Troubleshooting GuideThe following table provides a list of common failures and possible solutions.Symptom Messa

30 AUTOPAR® WASH LUMINAIRE USER MANUALROUTINE MAINTENANCEReplacing LampParts:71.2566.0700.0 LAMP, MSR 700WTools:#2 Phillips ScrewdriverWARNING: Remov

AUTOPAR® WASH LUMINAIRE USER MANUAL 31Aligning LampAfter a new lamp is installed, it will be necessary to align the lamp to optimize the beam. Screws

II AUTOPAR® WASH LUMINAIRE USER MANUALWARNING: INSTRUCTIONS FOR PROTECTION AGAINST INJURY TO PERSONS1) Exterior surfaces of the luminaire will be hot

32 AUTOPAR® WASH LUMINAIRE USER MANUALReplacing Front LensThe luminaire includes four different front lens which can be swapped as needed.Parts:LENS,

AUTOPAR® WASH LUMINAIRE USER MANUAL 33Installing a Color GelColor gels can be installed in the gel frame located at the front of the head assembly.Too

34 AUTOPAR® WASH LUMINAIRE USER MANUALCleaning the LuminaireTools:Window cleaner (commercial grade)Clean, lint-free clothVacuum cleaner with brush noz

A. TECHNICAL SPECIFICATIONS

36 AUTOPAR® WASH LUMINAIRE USER MANUALAutoPar Wash LuminaireDescriptionSOURCE: Philips MSR700 1CT 700W arc lampColor Temp: 5600°KCRI: 85BALLAST: Integ

AUTOPAR® WASH LUMINAIRE USER MANUAL 37Photometric DataAutoPar Luminaire with MSR700 Lamp* Multiply throw distance by Tn to determine coverage.**To cal

38 AUTOPAR® WASH LUMINAIRE USER MANUALNotes

AutoPar® Wash Luminaire User ManualVersion as of: November 8, 2010PRG part number: 02.9802.0001.21

Production Resource GroupDallas Office8617 Ambassador Row, Suite 120Dallas, Texas 75247www.prg.com

AUTOPAR® WASH LUMINAIRE USER MANUAL IIINotes de sécuritéAvant de procéder à l’installation des produits décrits dans ce guide et de les mettre en marc

IV AUTOPAR® WASH LUMINAIRE USER MANUALRevision HistoryThis manual has been revised as follows:Version Release Date NotesBASIC February 8, 2006 Softwar

AUTOPAR® WASH LUMINAIRE USER MANUAL VTABLE OF CONTENTSIntroductionAbout This Manual...

VI AUTOPAR® WASH LUMINAIRE USER MANUALAppendix A. Technical SpecificationsAutoPar Wash Luminaire .....

AUTOPAR® WASH LUMINAIRE USER MANUAL 1INTRODUCTIONAbout This ManualThis manual provides necessary information regarding product safety, installation, a